Honeywell Switch 220736B Manual de usuario

CONTENTSSpecifications ...2Ordering Information ... 2Installation ...

10Fig. 8—Auxiliary switch adjustment for M6184,M6194 motors.4. For switch differential of 1°, check continuity ofauxiliary switch N.O. (Red to Purple)

WARNINGFIRE OR EXPLOSION HAZARDCAN CAUSE SEVERE INJURY OR DEATHWhen auxiliary switches control combustionequipment, incorrect wiring of the switches c

220736A,BSETTINGS AND ADJUSTMENTSResidential and Residential and Helping You Control Your WorldBuilding Controls Division Building Controls DivisionHo

Specifications2MODELS: 220736A,B Internal Auxiliary Switches forTRADELINE Modutrol IV Motors. Switches are actu-ated by cams in the motor. The cams ca

8. Lower the switch assembly into place and tightenthe two mounting screws, making sure the switch follow-ers are properly aligned with the inner and

TABLE 1—AUXILIARY SWITCH LEADWIRE COLORS FOR LOW AND MEDIUM TORQUE SERIES 91 MOTORS WITHONE AUXILIARY SWITCH.Replace with220736A,BFactory-Installed Au

Replace with220736A,BFactory-Installed Auxiliary Switch Leadwire Colora,bLeadwireLeft N.O. Blue Blue W/Yellow PurpleAuxiliary N.C. Yellow Yellow W/Blu

TABLE 4—AUXILIARY SWITCH POSITION WITH MOTOR SHAFT ROTATED TO EITHER SIDE OFAUXILIARY SWITCH OPERATING POINT, AS VIEWED FROM POWER END.Auxiliary Switc

To turn the cams, insert small screwdriver (1/8" or3 mm blade) through wiring box into slot on cam and movethe screwdriver at the top. Refer to F

7. Check for proper switch differential and switchingof auxiliary equipment by driving the motor through fullstroke (in both directions) using the pot

220736A,BSETTINGS AND ADJUSTMENTS5. For switch differential of 10°, the cams must berotated with screwdriver approximately 180° prior tosetting the sw