Honeywell Vuquest 4980 Guía de usuario descargar pdf (Pagina 8)

Cable Installation

Important: If the cable is not fully attached, the unit may power intermittently.

Figure 2. Cable Installation

1. Insert the 15-pin D-type connector end of the cable into the socket on the

MS4980.

2. Rotate the two screws clockwise to tighten.

3. Gently pull on the cable strain relief to insure the cable is installed.

Cable Removal

Before removing the cable from the scanner, turn off power on the host system

and disconnect the power supply, if applicable.

Figure 3. Cable Removal

1. Rotate the two screws counter clockwise to loosen the screws.

2. Pull gently on the strain-relief of the cable to remove it from the scanner.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 51 52

Sin comentarios

Honeywell Vuquest 4980 Guía de usuario Pagina 8