Honeywell WT6500 Manual de usuario descargar pdf (Pagina 21)

SMARTBOX™ Controller for HONEYWELL™ Wind Turbine WT6500 Owner’s Manual - Rev14

SMARTBOX Installation

Turbine Over-current Protection

TheNECrequirestheturbinecircuittobeprotectedwithadeviceratedfor125%of

the rating of the circuit. The DC-rated fuse or circuit breaker between the turbine and

the SMARTBOX™ Controller must have a maximum size of 15 (the maximum current

rating of the SMARTBOX™ Controller).

SHOCK HAZARD OR FIRE HAZARD

Over-current protection must be installed to protect the

SMARTBOX™ Controller from short circuits and to provide

a means of disconnecting it. Failure to follow this warning

may result in death, personal injury or property damage.

REVERSE POLARITY DAMAGE

BeforemakingthenalDCconnectionorclosingtheDC

breaker or disconnect, check cable polarity at both the

battery and the SMARTBOX™ Controller. Positive (+)

must be connected to positive (+). Negative(-) must be

connected to negative (-). Failure to follow this warning may

result in death, personal injury or property damage.

TURBINE JUNCTION BOX

EARTH

GROUND

STAKE

TURBINE POLES

SEE TURBINE TO CONTROLLER SIZE

CHART ON SHEET 1

(2) #10 THWN-2 + #6 GND

¾” CONDUIT

MAX DISTANCE 3 FEET.

#4 GND

Figure 2.6 Turbine Circuit Diagram

TURBINE TO CONTROLLER WIRE SIZE CHART

TURBINE WIRE MAX DISTANCE (FT) EMT CONDUIT (INCH)

#10 (#6 GND) 3/4

#8 (#4 GND) 1

150

200

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 45 46

Sin comentarios

Honeywell WT6500 Manual de usuario Pagina 21