Honeywell C7089 Manual de usuario descargar pdf

® U.S. Registered Trademark

INSTALLATION INSTRUCTIONS

C7089

Outdoor Sensor

(USE WITH TH8000 AND TH7000 THERMOSTATS)

APPLICATION

This C7089 Outdoor Sensor is used with theTH8000 and

TH7000 Thermostat families.

SPECIFICATIONS

Operating Ambient Temperature Range:

-40 to 120°F (-40 to 49°C).

Display Range:

-40 to 127°F (-40 to 53°C).

Sensor Accuracy:

+/-1.5°F at 70°F (+/-.84 at 21°C)

Operating Relative Humidity:

5% to 95% non-condensing.

Dimensions in in. (mm):

2-1/4 (57) x 3/8 (10) with 60 (1524) leadwires.

INSTALLATION

When Installing this Product…

1. Read these instructions carefully. Failure to follow

them could damage the product or cause a hazard-

ous condition.

2. Check the ratings given in the instructions and on

the product to make sure the product is suitable for

your application.

3. Installer must be a trained, experienced service

technician.

4. After installation is complete, check out product

operation as provided in these instructions.

CAUTION

Electrical Shock Hazard.

Can cause electrical shock or equipment

damage.

Disconnect power supply before connecting

wiring.

Location and Mounting (Fig. 1)

Mount the sensor where:

• cannot tamper with settings.

• there is good air circulation.

• it can measure true outdoor ambient temperature.

• surface is flat.

• wire distance between C7089 and thermostat is less

than 200 feet.

Do not mount the sensor:

• in direct sunlight.

• where hot or cold air blows on the sensor. Discharge

line from an outdoor compressor unit, vent or fan

causes inaccurate temperature readings.

• where snow, ice or debris can cover it.

Use the following steps to mount the sensor:

1. Remove the sensor from the mounting clip.

2. Mark the area on the location selected for

mounting the sensor mounting clip.

3. Mount the clip.

Fig. 1. Typical locations for outdoor sensor.

M7514

1 2 3 4 5 6 ... 11 12

Indice de contenidos

Pagina 1 - Outdoor Sensor

Pagina 2 - 69-1709EFS 2

C7089 SENSOR EXTERIOR69-1709EFS 2CableadoPRECAUCIÓNRiesgo de interferencia eléctrica (ruido). Puede provocar una operación errática del sistema. Mante

Pagina 3 - CALIBRATION

C7089 SENSOR EXTERIOR3 69-1709EFSOPERACIÓNUna vez que esté instalado y que el número 0340 de configuración del instalador del termostato se cambie de

Pagina 4

69-1709EFS G.H. 03-04 www.honeywell.comC7089 SENSOR EXTERIORAutomatización y control desenlaceHoneywell International Inc. Honeywell Limited-Honeywe

Pagina 5 - Capteur extérieur

C7089 OUTDOOR SENSOR69-1709EFS 2WiringCAUTIONElectrical Interference (Noise) Hazard.Can cause erratic system operation. Keep wiring at least one foot

Pagina 6 - AVERTISSEMENT

C7089 OUTDOOR SENSOR3 69-1709EFSOPERATIONOnce installed and the Thermostat Installer Setup Number 0340 is set to 1 or 2, the outside temperature can b

Pagina 7 - ÉTALONNAGE

69-1709EFS G.H. 03-04 www.honeywell.com/yourhomeC7089 OUTDOOR SENSORAutomation and Control SolutionsHoneywell International Inc. Honeywell Limited

Pagina 8

Pagina 9 - Sensor exterior

C7089 CAPTEUR EXTÉRIEUR69-1709EFS 2CâblageAVERTISSEMENTRisque d’interférences électriques.Peut provoquer le fonctionnement erratique du système.Tenir

Pagina 10 - PRECAUCIÓN

C7089 CAPTEUR EXTÉRIEUR3 69-1709EFSFONCTIONNEMENTUne fois le capteur installé et le numéro de configuration par l’installateur 0340 réglé à 1 ou 2, la

Pagina 11 - CALIBRACIÓN

69-1709EFS G.H. 03-04 www.honeywell.com/yourhomeC7089 CAPTEUR EXTÉRIEURSolutions de régulation et d'automatisationHoneywell International I

Pagina 12