Honeywell CT1503 Manual de usuario

HoneywellCT1500, CT1501, CT1502, CT1503 ELECTROMECHANICAL FUEL SAVER THERMOSTAT AND WALLPLATE/SUBBASECT1500—24 V gas or oil heat.CT1501 —24 V gas or o

TABLE 2—TERMINAL DESIGNATIONS.OLD SUBBASE TERMINALCONTROL FUNCTIONR or RHHeating transformer power to control circuit.RCCooling transformer power

CT1502, continuedSlUGLE STAGE HEAT PUMP {WiTHOUT AUXILIARY HEAT) SYSTEMIFCOMPRESSOR IS CONNECTED TO OLD THERMOSTAT'S y TERMINAL WITH A JUMPER TO

MOUNT THE THERMOSTAT□ Note the tabs on the top inside edge of the thermostat base. These fit the slots molded into the top of the wallplate or su

SET HEAT ANTICIPATOR LEVERNOTE: Not applicable on CT1503 millivolt model,□ The thermostat’s adjustable heat anticipator must be correctly set to

□ On the CT1500, CT1501 or CT1502 thermostats, move the heat anticipator indicator to match the number you recorded rn Step 4 or tound on the pr

SET TIMER□ Adjust the timer by moving the knob in clockwise ^ direction. Do NOT reverse the knob.□ When time is correctly set, the Time In

ATTACH THERMOSTAT COVER□ Make sure the packing inserts in the thermostat base have been removed, as explained i n step 3.□ Place the two tabs on uppe

CHECK OUT THERMOSTAT OPERATION AND SET TEMPERATURE CONTROL LEVERS□ The two levers on top of the thermostat control the low and high tempe

Heating-only System□ Turn on power to the furnace,Pushbothtemperaturecontrolleverstogetherat least 5“ F [3“ C] above room temperature. The heat should

□ After checkout, reset both temperature levers to desired temperatures.For heating season:□ Move the blue lever to the energy savings temper

THERMOSTAT FEATURESI—Front of thermostat.HIGHH—Hinged cover lifted.I—Cover removed.24 HOUR PROGRAM DIAL (GREY AREA FOR NIGHT SETTINGS)AAA ALKALI BATTE

HoneywellResidential and Building Controls UivislonHoneywell Inc.1985 Douglas Drive No. Golden Valley, MN 55422Residential and Building Controls Divis

PREPARATIONCheck thermostat and wallplate suitability for your heating or heating/cooling system. Refer to Table 1,THERMOSTATMODELSUBBASE OR WALLPLATE

□ If wallplate or subbase is mounted on a vertical outlet box (check old installation), order 196393A Cover Plate and Adapter Ring (see appropri

REMOVE OLD THERMOSTAT□ Remove cover of old thermostat. If the cover doesn't snap off when pulled firmly from the bottom, check for a screw that l

MOUNT WALLPLATE OR SUBBASEHEATINQCOOLINGSUBBASE□ If mounting on outlet box, mount as shown on appropriate figure.□ If mounting on wall, hold wallplate

3 SCREW h40LES WITH PLASTIC ANCHORSH£ATlNG«:OOUNG SUBBASE□Carefully level the wallplate or subbase and firmly tighten screws.___________SPIR)T LEVELen

WIRE WALLPLATE OR SUBBASENOTE: All wiring must comply with local eleotrical codes and ordinances.□ Refer to illustration and strip thermostat wire ins

For CT1501 heating/cooling□ Connect the wires to matching terminals on the subbase.APOWER SOPPLV, PROVIDE DISCONNECT MEANS AND OVERLOAD PROTECTION A