Honeywell Scanner MS9520 Manual de usuario descargar pdf (Pagina 42)

7–10

³ 1 4 1 7 1 5

Use Protocol Prefix and Suffix for Bar Code

Transmission

³ 1 4 1 7 0 5

* No Protocol Prefix and Suffix for Bar Code

Transmission

³ 1 1 9 9 1 7

Enable RTS on No Read

– After a NOREAD

occurs, the scanner will activate the RTS line for

20 milliseconds. The duration of the RTS

activation can be loaded in address 199 bits 6–0

in 10 millisecond steps.

³ 1 1 9 9 0 7

* Disable RTS on No Read

Test Modes

³ 1 1 8 0 1 6

Scan Count Mode ON – The scanner will enter

scan count test mode and the scanner’s firmware

number will transmit to the host. Do not enable

unless instructed by a Honeywell representative.

³ 1 1 8 0 0 6

* Scan Count Mode OFF

³ 1 1 5 5 1 2

Power-Up with Saved Interface – Do not

enable unless instructed by a Honeywell

representative.

³ 1 1 5 5 0 2

* Power-Up with Board Interface – Do not enable

unless instructed by a Honeywell representative.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 115 116

Sin comentarios

Honeywell Scanner MS9520 Manual de usuario Pagina 42